Electrical Engineer (Qatar Exam) Test-21

FemaleMale
20 Questions - Developed by:
- Developed on: - 959 taken - 3 people like it

Qatar engineering registration exam preparation

  • 1
    A system with an initial cost of s 90,000 has an operating cost of s 2.50/hr and is operated 16 hr/day for 300 days/year. After 10 years, the system has a salvage value of s 10,000, Assuming the interest rate is constant at 10%, the total annualized cost over the 10-year life is
  • 2
    System with a n initial cost of 90000 dollars has an operating cost of 2.50 dollars per hour and is operated 16 hr /day for 300 days/year. After 10 years, the system has salvage value of 10000 dollars. Assuming the interest rate is constant at 10% the total analyzed cost over the 10-year life is most nearly
  • 3
    A SCADA system configuration requires maximum values (i.e., the actual value of current when the transducer is at full scale). The transducer ahs a fll-scale ac current of 5A. Sing a current transformer wit a trns raito of 400.5. the maximum current value (amperes) is most nearly

  • 4
    The most important end state of project initiation is
  • 5
    Following successor relationships are available for a project. What is the duration of the project?
    Following successor relationships are available for a project. What is the duration of the project?
  • 6
    When the receiver in previous question is turned to 540 kHz station, what other AM station offers ^ potential interference?

  • 7
    The main activity in project scope definition is to
  • 8
    This is a type of semiconductor that only allows current ot flow in one direction. it is usually used to rectify AC signals (conversion to DC)
  • 9
    Three 30-pF capacitors are connected in star (Y) form between the terminals A, B, C and a junction point N as shown in the figure, the capacitance (pF) between terminals A and B is most nearly.
  • 10
    The Output D in the circuit is.
    The Output D in the circuit is.

  • 11
    For the diagram shown, what is the approximate required minimum clearance distance, R, if the phase voltage of the live parts is 13,800 V?
  • 12
    The output is to be maintained at 24 V, while the input varies from 120 V to 126 V with a load current ranging from OA to 5A . Assume ideal conditions, that is the keep alive current is zero and the zener resistance Rz is negligible
  • 13
    A large-scale integrated (LSI) circuit is shown in the figure below. What is the best description of the circuit?
    A large-scale integrated (LSI) circuit is shown in the figure below. What is the best description of the circuit?
  • 14
    A 3-phase distribution line conductor configurations a s follows *3ft —>* 4ft —>*
  • 15
    We have three resistances each of 1 ohm. How many different values of resistance can be obtained by different series-parallel combinations if all the three resistances are to remain in the circuit?
  • 16
    The system shown is stable for
    The system shown is stable for

  • 17
    An ac voltmeter with a full-scale range of 5V is used to measure the output voltage of an amplifier. The amplifier has an out put impedance of 2000 'Q, and the meter has a sensitivity of 2000 'Q/v. When connected to the amplifier, the meter reads 2.5 V . if a different meter with a sensitivity of 100000 'Q/V and a fll scale meter of 5V is connected to the amplifier, the voltmeter reading (V) will be
  • 18
    The out put is to be maintained at 24v while the input varies from 120 v to 126 v with a load current ranging from 0 A to 3A . Assume ideal conditions that is the keep alive current its zero and the zero resistance R is negligible.What is the required supply resistance to ensure proper operation of the zenar regulator circuit.
    The out put is to be maintained at 24v while the input varies from 120 v to 126 v with a load current ranging from 0 A to 3A . Assume ideal conditions
  • 19
    When a fuse is rated 8A, it means
  • 20
    The travelling cranes are mostly driven by:

Comments (0)

autorenew